PiCapture HDMI Capture Board – Only detects/sync with camera at power on Reply To: HDMI Capture Board – Only detects/sync with camera at power on

#900
mwlinder
Keymaster

When it is in “auto” source mode, it cycles through the various inputs/resolutions. If there is nothing connected to the component input, then it should come back to HDMI and see that the input has been restored. I’m not yet why that isn’t working.

Once you set the source to HDMI, it will not cycle through and just keep looking at that input. If the source setting is HDMI does it come back when your camera powers up?

Does your camera support any progressive video modes? If so, it would also be interesting to try a different mode and see if it behaves differently.

mwlinderReply To: HDMI Capture Board – Only detects/sync with camera at power on